Thrifty Nova
  • Software Resources
    • Getting Started
    • Configure Controller Settings
      • Factory Default
      • Motor Type - Minion Setting
      • Inverting the Motor
      • Brake Mode
      • Maximum Output
      • Ramp Up/Ramp Down
      • Current Limiting
      • Soft Limits
      • Hard Limits
      • Setting Encoder Position
      • Follower Mode
    • Configure Onboard PID
    • Configure CAN Frequency
    • IO Signal Management
    • Set Output
    • Logging
    • Get Feedback
    • Unit Conversions
    • Subsystem Examples
      • Simple Elevator Example
      • Swerve Module Example
      • Simple Arm Example
  • Electrical Resources
    • Wiring the Thrifty Nova
    • LED Color Codes
    • Brushless Hall Sensor Connector
    • USB Communications
    • 10 Pin Data Connector
      • Intro to Sensors
      • Sensor Hat
      • Motor Runner Board
    • Hard Reset
  • Mechanical
    • Mounting Options
  • Software Releases
    • Software Releases
  • Thrifty Config
    • Thrifty Config Demo Video
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Electrical Resources
  2. 10 Pin Data Connector

Motor Runner Board

PreviousSensor HatNextHard Reset

Last updated 6 months ago

Was this helpful?

The motor runner board allows for reversing (via switch) and powering the motor (via the integrated slide potentiometer. The board sends a signal to the processor to enable it in "Slider Mode", turning off USB and CAN control. We designed this to make prototyping with brushless easier, just wire a ribbon cable to it and away you go!

is a link to the OnShape with the printed case included.

Here
Motor Runner Board